SLV NUMINOS M CL PHASE 1004240 is a surface-mounted LED ceiling light with a narrow cylindrical body. Its white aluminium housing contrasts with the black rim around the light opening, without a hanging cable, branching arms or a decorative shade.
A cylinder below the ceiling
The fitting measures 8.5 cm in diameter and 18.5 cm in height. It mounts onto the ceiling surface rather than into a recessed cut-out. Allow for the body projecting below the ceiling when choosing its position, as well as the downward direction of the light. The clean geometry suits modern and minimalist interiors where the lighting follows the room's architectural lines rather than adding ornamental detail.
Neutral white light with a 60° beam
This version delivers 1950 lm with a power consumption of 14 W. Its 4000 K colour temperature produces neutral white light, distinct from the warmer 2700 K and 3000 K versions in the family. A CRI of 90 is relevant when assessing the appearance of coloured fabrics, objects and finishes under artificial light.
The 60° beam spreads light more broadly than the narrow-beam versions, while still directing it downwards. Consider it for a hallway, entrance area, dressing room, living room or kitchen, including positions above a table or kitchen island. The ceiling height and required illumination of the surface should guide the number and spacing of fittings. A single lumen figure does not establish coverage of an entire room.
Control and servicing
Dimming requires a compatible trailing-edge phase dimmer; this PHASE version does not use DALI control. Check the regulator's compatibility and minimum load before selecting it, particularly when connecting only a small number of lights.
The supply is 220–240 V AC. Installation requires an approved electrician, and the class I fitting must be connected to a protective earth conductor. Only a professional may replace the light source or control gear. The manual specifies fixed mounting on an even indoor surface. Clean only the exterior with a cloth lightly moistened with water, after disconnecting the power and allowing the fitting to cool.